Mounting The Access Point; Routing And Connecting Ground, Ac Power, And Ethernet Backhaul Cables - Cisco Aironet 1550 Series Hardware Installation Manual

Outdoor mesh access point
Hide thumbs Also See for Aironet 1550 Series:
Table of Contents

Advertisement

Chapter 2
Installing the Access Point
Label Text
Ex nA II T5
CSA Certificate 1945576
-40 < Ta < +55C
Type 4, IP67

Mounting the Access Point

You can mount the access point using any of the mounting systems described in this document. Follow
the instructions in the appropriate section or sections for the installation you intend to use.

Routing and Connecting Ground, AC Power, and Ethernet Backhaul Cables

After you have mounted the access point, you must route ground, AC power, and backhaul Ethernet
cabling to the access point using rigid steel conduit.
When you install the conduit, be sure to comply with the local electrical codes for your area.
Note
The procedure is divided into six parts:
1.
2.
3.
4.
5.
OL-24247-01
"Installing the PG-13 1/2 NPT Conduit Adapters" section on page 2-64
"Opening the 1552H Access Point Hinged Cover" section on page 2-65
"Connecting Ground and AC Power" section on page 2-66
"Closing the 1552H Access Point Hinged Cover" section on page 2-68
"Connecting the Ethernet Backhaul Cable" section on page 2-68
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
Installing the Access Point in Hazardous Locations
Description
Defines parameters that the product complies with for U.S.
Certification:
Ex —Denotes explosive atmosphere
nA —Non-sparking
II = Group II as defined previously
T5 = Temperature code < 100 degrees C, maximum surface
temperature
Identifies the Canadian Standards Association (CSA) certificate
number.
The operating temperature range for the access point in all
countries.
Current safety certifications only include
Note
operation of this outdoor equipment down to
-40C.
Defines the enclosure degree of protection (Type 4 = indoor or
outdoor use primarily to provide a degree of protection against
windblown dust and rain, splashing water, hose-directed water, and
damage from external ice formation. IP67 = Dust tight (dust, dirt,
sand, and so forth) and protected against powerful water jets. Also,
the unit can be immersed in water up to 1m for short periods of time
(30min).
2-63

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents