Removing A Backup Battery - Cisco Aironet 1550 Series Hardware Installation Manual

Removing a Backup Battery

Removing a Backup Battery
To remove a backup battery, follow these steps:
Step 1 While holding the access point cover open, carefully disconnect the backup battery cable from the
internal connector (see
Figure 4-2
1
2
Carefully place the cover onto your static-protected table.
Step 2
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
4-4
Figure 4-2). Be careful not to touch the radio board components.
Battery Backup Location
Backup battery
Backup battery cable
Chapter 4 Installing or Replacing the Backup Battery
3 Internal connector for the backup battery cable
4
Radio boards (Do not touch)
OL-24247-01