Installing the Access Point in Hazardous Locations
Connecting Ground and AC Power
To route and connect the ground and AC power cabling to the 1552H access point model, follow these
steps:
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
Always install the ground wire before connecting the AC power leads.
Caution
Step 1
Open the access point hinged cover. See the
on page 2-65
Step 2
Use a Phillips head screwdriver to loosen the three captive screws that secure the AC entry module cover.
(Figure
Figure 2-49
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-66
for instructions.
2-49).
AC Power Installation—Model AIR-CAP1552H-A-K9
3
2
1
"Opening the 1552H Access Point Hinged Cover" section
4
Chapter 2
Installing the Access Point
5
OL-24247-01