Before Beginning The Installation - Cisco Aironet 1550 Series Hardware Installation Manual

Chapter 2 Installing the Access Point
•

Before Beginning the Installation

Before you begin the installation process:
•
•
•
•
•
•
Becoming Familiar with Access Point Installation Components
The access point is designed to be installed in an outdoor environment, such as the exterior roof overhang
of a tall building or a streetlight pole. Carefully review the following figures to become familiar with the
system components, connectors, indicators, cables, system interconnection, and grounding:
•
•
•
•
Note The illustrations in this document show all available connections for the access point. Unused
connections are capped with a connector plug to ensure the watertight integrity of the access point,
except for the AC power entry connector on the 1552E access point. Liquid-tight adapters are provided
for connector openings, which can be installed before or after deploying the access point.
When not using the AC input connector to power the 1552E (for example when powering using the Cisco
power injector), it is important to cover the AC power entry connector. The correct cap is Remke part
number 75-0086 (http://www.remke.com/).
OL-24247-01
Obstructions—Physical obstructions such as buildings, trees, or hills can hinder performance of
wireless devices. Avoid locating the devices in a location where there is an obstruction between the
sending and receiving antennas.
Ensure that a site survey has been performed.
Ensure that your network infrastructure devices are operational and properly configured.
Ensure that your controllers are connected to switch trunk ports.
Ensure that your switch is configured with untagged access ports for connecting your access points.
Ensure that a DHCP server with Option 43 configured is reachable by your access points, or
manually configure the controller information in the access point (for additional information, refer
to the "Configuring DHCP Option 43" section on page
Become familiar with the access point installation components (see the
Access Point Installation Components" section on page
Components in a typical access point installation (see
Pole mount installation (see
Cable strand mount installation (see
Streetlight power tap installation (see
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
Figure
Figure 2-2)
Figure 2-3)
Figure 2-4)
Installation Guidelines
F-1).
"Becoming Familiar with
2-9).
2-1)
2-9