Chapter 1
Overview
Network Deployment Examples
Point-to-Multipoint Bridging
The access points can be used as a RAP to connect multiple remote MAPs with their associated wired
networks. By default this capability is turned-off for all access points. To support Ethernet bridging, you
must enable bridging on the controller for each access point. Wireless client access can be provided over
the bridging link; however, if bridging between tall buildings, the 2.4-GHz wireless coverage area may
be limited and possibly not suitable for direct wireless client access.
Figure 1-12
illustrates an example
of access point-to-multipoint bridging.
Figure 1-12
Access Point to Multipoint Bridging Example
(5 GHz)
(5 GHz)
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
1-20
OL-24247-01