Cisco Aironet 1550 Series Hardware Installation Manual page 152

Table E-3
Table E-3
Pin Number
1
2
3
6
4
5
7
8
Shield
Table E-4
Table E-4
Pin Number
1
2
3
6
4
5
7
8
Shield
The power injector output connector (To AP) only supplies 56 VDC power when the Ethernet cable is
Note
connected to the 1550 PoE-in connector.
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
E-2
describes the pin signals for the power injector input connector (To Switch).
Power Injector Input Connector (To Switch) Pinouts
Signal Name
Ethernet signal pair (10/100/1000BASE-T)
Ethernet signal pair 10/100/1000BASE-T)
Ethernet signal pair (1000BASE-T)
Ethernet signal pair (1000BASE-T)
Chassis ground
describes the RJ-45 pin signals for the power injector output connector (To AP).
Power Injector Output Connector (To AP) Pinouts
Signal Name
Ethernet signal pair (10/100/1000BASE-T) and 56 VDC return
Ethernet signal pair (10/100/1000BASE-T) and 56 VDC (+)
Ethernet signal pair (1000BASE-T) and 56 VDC (+)
Ethernet signal pair (1000BASE-T) and 56 VDC return
Chassis ground
Appendix E Access Point Pinouts
OL-24247-01