Installing A New Backup Battery - Cisco Aironet 1550 Series Hardware Installation Manual

Chapter 4 Installing or Replacing the Backup Battery
Use a Phillips screw driver to remove the four screws attaching the backup battery to the cover
Step 3
(see
Figure 4-3
1
2

Installing a New Backup Battery

Note The AIR-1520-BATT-6AH= backup battery is used only on access point model AIR-CAP1552E-x-K9.
Do not use this battery on model AIR-CAP1552H-x-K9.
To install a new backup battery into your access point, follow these steps:
Carefully orient your new backup battery as shown in
Step 1
Position the backup battery over the four screw holes in the radio cover.
Step 2
Use the four supplied screws to attach the backup battery to the radio cover and tighten to 5.5 to 6.5 in.
Step 3
lbs (0.62 to 0.73 Nm).
Position and bend the backup battery cable as shown in
Step 4
OL-24247-01
Figure 4-3).
Backup Battery Screws
Battery backup screws (4 places)
Battery backup cable and connector
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
Installing a New Backup Battery
3
Backup battery
4
Access point radio cover
Figure 4-3 over the access point radio cover.
Figure 4-3.
4-5