Chapter 2
Installing the Access Point
Antenna N-Type Connector Locations
The access point antenna N-type connectors are located on the bottom of Models AIR-CAP1552E-x-K9
and AIR-CAP1552H-x-K9. The N-type connectors support the Cisco Aironet AIR-ANT2547V-N
Dual-Band Omnidirectional Antennas.
cover side.
Figure 2-5
1
2
3
Adding the Access Point MAC Addresses to the Controller Filter List
Before installing your access points, configure your controller by adding the MAC addresses of the
access points to the filter list. MAC address filtering is enabled by default. This enables the controller to
respond to the listed access points. To add a MAC filter entry on the controller, follow these steps:
Step 1
Log into your controller using a web browser.
Step 2
Choose SECURITY > MAC Filtering > New.
Enter the MAC address of the access point to the MAC Filter list; for example, 00:0B:91:21:3A:C7.
Step 3
Note
Step 4
Select a WLAN ID or Any WLAN from the WLAN ID pop-up menu.
OL-24247-01
Antenna Port Locations - Models AIR-CAP1552E-x-K9 and AIR-CAP1552H-x-K9
Not used
Not used
Not used
The access point MAC address is located on the bottom of the unit. When two MAC addresses
are shown, use the top MAC address.
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
Figure 2-5
shows the antenna port locations viewed from the RF
3
2
6
5
4
Antenna port 4 (with caps)
5
Antenna port 5 (with caps)
6
Antenna port 6 (with caps)
Installation Guidelines
1
4
2-13