Otto Bock Kimba KRUZE User Manual page 17

Headwings:
Before headwings installing, install and adjust first the 5- point positioning belt.
Install:
The highest position: - seat the child into the buggy and determine appropriate height of headwings, take the child
out of the buggy. Place headwings on the buggy in desired height and put longer Velcro through the ensued holes
on the backrest ( see PIC2) and turn the shorter Velcro over upper edge of the backrest. Fasten Velcro on the back
side ( see PIC3). Finally, secure headwings using side straps on the back side of the backrest by Velcro. ( see
PIC4).
Lower position - pass longer Velcro in desired height through the holes on the backrest, and put also shorter Velcro
through ensued holes. Fasten Velcro on the back side. Finally, secure headwings using side straps on the rear of the
backrest by Velcro (see PIC4).
Uninstall - follow chapter ―install‖, but in reverse sequence.
PIC1
PIC3
PIC5
PIC2
PIC4
17