Otto Bock Kimba KRUZE User Manual page 16

2 point positioning belt :
Install - release central buckle fasteners. Loop both lower webbing ends (with webbing loops) to anchoring points.
Anchor the belt webbing with the plastic slip lock with labyrinth-like fastening ( see PIC1 and PIC2). Connect
both fasteners of the plastic buckle. (see PIC3).
Uninstall - follow chapter ―install‖, but in reverse sequence.
Size adjustment - release central buckle fasteners, place the child into the buggy. Pull both side D-rings to adjust
the length of straps to desired , comfortable size (see PIC4)
PIC1
PIC3
Headrest (pair):
Before headrest installing, install and adjust first the 5- point positioning belt.
Install:
The highest position: - pass the shorter lower belts with Velcro through top holes on backrest (see PIC1) and flip the
longer top belts with Velcro over backrest edge. (see PIC2). Secure the belts on the rear of the backrest by putting
the Velcro together (see PIC3).
The lowest position: - pass the shorter lower belts with Velcro through the holes on the backrest according your
height and the longer top belts with Velcro through the holes above the shorter belts. Secure the belts on the rear of
the backrest by putting the Velcro together.
Uninstall - follow chapter ―install‖, but in reverse sequence.
Size adjustment - It is necessary to set the headrest width before installing the headrest on the buggy backrest. To
set the size, on the lower belts of the padding first release snap buttons and put off the padding from the main belt.
Turn it by 180 degrees and assemble again. Fasten the padding by pressing the snap buttons on the lower belts.
PIC2
PIC4
16