Cable Routing - Yamaha YW50AP Service Manual

CABLE ROUTING

1 Horn
2 Rectifier regulator
3 Main switch
4 Headlight leads
5 Speedometer cable
6 Ignition coil
7 Throttle cable 1
8 Throttle cable 3
9 Battery negative(-)
0 Wire brake
q Fuel sender lead
w Seat lock cable
e Oil tank hose
r C.D.I. unit
w
q
t Wire harness
A Pass the speedometer cable
through the right hole of front
fender, then through the
guide.
B Pass the wire harness through
the inside of ignition coil.
C Secure the ground lead and
the ignition coil base to the
ignition coil stay.
D Pass the wire harness through
the inside of oil tank.
E Pass the seat cable through
the inside of frame.
F Align the clip with the white
0
8
7
t
e
r
8
2-14
CABLE ROUTING
brand.
G Clamp the wire harness.
H Insert the seat cable through
the frame tube.
I Clamp wireharness, rear
brake cable throttle cable 1,3.
J Position the cylinder between
the supporter and main
switch.
3
7 9 6
SPEC
1
2
4