Cable Routing - Yamaha YP250 98 Supplementary Service Manual

CABLE ROUTING

1 Box light
2 Rectifier/ regulator
3 Fuel sender
4 Roll over valve
5 Fuse
6 Seat lock cable
7 Handlebar switch lead (right)
8 Front brake switch lead
9 Brake hose
10 Speedometer cable
11 Pipe
12 Starter relay
13 Battery
14 Flasher relay
CABLE ROUTING
15 Reservoir tank
16 Battery negative (–) lead
17 Battery positive (+) lead
18 Ignition coil
19 Breather hose
20 Air filter
21 Mudguard
22 Seat lock cable
23 Down tube
24 Wireharness
25 Ground lead
26 Engine bracket
27 AC magnet leads
28 Starter motor lead
6
SPEC
A Pass the box light lead from
outside of frame through
inside of protector.
B Clamp the fuel sender lead to
the pipe.
C Clamp the fuel sender lead
and auto choke lead to the
frame.
D Pass the box switch lead
through under the fuel tank
hinge projection.
E Align the mark on seat lock
cable to the protector end.
F Clamp the wireharness
(white tape) to frame.