Firmware Upload; Environmental Conditions; Connectors; Ethernet Connector - NEC Electra Elite IPK Installation And Maintenance Manual

Electra Elite IPK
___________________________________________________________________________________
2.6
S 3 C
ECTION ONNECTORS
3.1
3.2
3.3
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual
2.5.4

Firmware Upload

The green LED on the Ethernet connector will light when data is
being transferred via the Ethernet port. When upload data is being
stored in nonvolatile memory, LED 3 will light momentarily.

Environmental Conditions

The following environmental conditions apply to the SPE(M)-U10 ETU.
Operating Temperature:
Operating Humidity:

Ethernet Connector

A 10/100Mbps Ethernet connector is used by the SPE(M)-U( ) ETU to directly
allow the connection with System Administration Terminal (SAT), Least Cost
Routing (LCR), and SPE Application. The Ethernet connector can also be
used for Station Message Detail Recording over Ethernet (SMDRoE).

COM Ports

There are four physical COM ports on the front edge of the SPE(M)-U( ) ETU
— COM A, COM B, COM C and COM D. COM A and COM B are configured
as DCE devices and cannot be changed. COM C and COM D are configured
as DCE devices at default and can be changed by dip switch SW 1 for COM D
and SW 2 for COM C for DTE devices when needed.

Memory Card

This will be used in the future.
Document Revision 1
° ° °
+32 to 104 F (0 to 40
0% to 90% (non-condensing)
°
C)
1 - 7