NEC Electra Elite IPK Installation And Maintenance Manual page 28

Electra Elite IPK
___________________________________________________________________________________
IP Address: (Default value: 192.168.1.100)
This is the static IP address that is needed for the configuration. Currently, DHCP is
not supported.
Subnet Mask: (Default value: 255.255.255.0)
Enter the Subnet mask for the SPE(M)-U( ) ETU. This is the same one you have been
using on the subnet.
Default Gateway: (Default value: 192.168.1.1)
Enter the default gateway for the SPE(M)-U( ) ETU in this field.
SMDRoE Status: (Default Disabled)
This setting is used to allow or disallow SMDR over the Ethernet. The appropriate
programming is required from the main CPU side in order for the SPE(M)-U( ) ETU to
output SMDR records. For more detail information pertaining to SMDR, refer to the
Station Message Detail Recording (SMDR) section of the Features and Specification
Manual.
SMDRoE IP Address: (Default 0.0.0.0)
Enter the IP Address of the device that will be set to receive the SMDRoE records.
SMDRoE TCP Port: (Default 50563)
This is the TCP Port number used for transmitting the SMDRoE records over the
network. NEC recommends leaving this field at its default value, unless otherwise
specified by the network administrator.
SPE App TCP Port: (Default 52992)
This is the TCP Port number used for transporting the SPE Application over Ethernet
and SAT (System Administration Terminal). NEC recommends leaving this field at its
default value, unless otherwise specified by the network administrator.
TFTP Server IP Address: (Default 0.0.0.0)
This is the IP Address for the TFTP server. This is only used when the SPE(M)U-10
ETU is to have a firmware upgrade performed.
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual
When the IP Address, Subnet Mask, or Default Gateway is changed the SPE(M)-U10
ETU must be rebooted in order to make the changes become active.
Document Revision 1
A - 3