Table 3-2 Network Settings For The Pc - NEC Electra Elite IPK Installation And Maintenance Manual

Document Revision 1
___________________________________________________________________________________
S 2 PC P
ECTION
The initial configuration is performed using a PC (or laptop computer) connected to
the SPE(M)-U( ) ETU using a crossover Ethernet cable (one-to-one connection) or
connecting with a hub. Make sure that the PC has the networking parameters set as
shown in
Boot up a client-enabled PC that is connected to the same network as the
SPE(M)-U( ) ETU.
Connect to the SPE(M)-U( ) ETU via your web browser using the default IP Address
192.168.1.100. Login to the SPE(M)-U( ) ETU with the following:
Set the IP Address, Subnet Mask, Computer Name, and Default IP parameters in the
SPE(M)-U( ) ETU configuration tab. Select Submit and then perform a SPE(M)-U( )
ETU Reset. Refer to
S 3 S
ECTION HUTDOWN
The SPE(M)-U( ) ETU is a hot, swappable ETU and can be removed from the Electra
Elite IPK KSU without powering down the SPE(M)-U( ) ETU or the Electra Elite IPK
system.
If the Electra Elite IPK KSU requires a system reset, the SPE(M)-U( ) ETU will come
back online.
___________________________________________________________________________________
3 - 2
ARAMETERS
Table 3-2 Network Settings for the

Table 3-2 Network Settings for the PC

IP Address
Subnet Mask
Appendix A Web-Based Setup and
P
ROCEDURE
PC.
192.168.1.XXX
255.255.255.0
Login ID = admin
Password = password
Electra Elite IPK
Configuration.
SPE(M)-U( ) ETU Configuration