Paper Rolled In The Fuser - Xerox Phaser 3250 Service Manual

Error Messages and Codes

Paper Rolled in the Fuser

Applicable Error Code
Initial Actions
3-20
There is an accordion jam in the Fuser. There is contamination at intervals of
77.6 mm on the back of the paper.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes
for the Fuser to cool before removing the Fuser.

Paper Rolled in the Fuser

Ensure that the Fuser is secured to the printer.
Cycle printer power.
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL9.1.0
Thermistor Assembly, PL9.1.5
Thermostat, PL9.1.7
Heat Roller, PL9.1.10
Guide Claw, PL9.1.16
Pressure Roller #1, PL9.1.21
Pressure Roller #2, PL9.1.23
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Fuser for contamination.
1
2. Is the Fuser dirty?
Wiring and Plug/Jack Map Reference
"Map 7 - LVPS, HVPS, Fuser, Developer
Unit CRUM, and Power Switch" on
page 10-15
Yes No
Disassemble the Go to step 2.
Fuser and clean
the debris
between the
Heat Roller
(page 8-17),
Thermistor
(page 8-15), and
Pressure Rollers
(#1 - page 8-20;
#2 - page 8-22).
Go to step 2.
Phaser 3250 Laser Printer Service Manual