Table of Contents
Advertisement
Chapter 12. Advanced setup
Warning: for experienced users only!
Press {Advanced} in the setup menu to go to the advanced setup.
12.1 DMX Config
The standard DMX refresh rate of the Xciter is 33 Hz. Some fixtures may not work at this rate. In that case,
you need to adjust the DMX timings.
1. Press {DMX Config} in the advanced setup.
2. Press {MBB} to adjust the Mark Before Break length.
Use ARROW or SCR1 to modify the value.
Press [ENT] to keep the new value, [ESC] to decline and return to the previous value.
3. Press {BREAK} to adjust the Break length.
Use ARROW or SCR1 to modify the value.
Press [ENT] to keep the new value, [ESC] to decline and return to the previous value.
4. Press {MAB} to adjust the Mark After Break length.
Use ARROW or SCR1 to modify the value.
Press [ENT] to keep the new value, [ESC] to decline and return to the previous value.
5. Press {CHSPACE} to adjust the space between channels.
Use ARROW or SCR1 to modify the value.
Press [ENT] to keep the new value, [ESC] to decline and return to the previous value.
In case you want to restore the values to factory default, press the SM bounce button below the label 'Deflt'.
6. Press [STORE] if you wish to store the new DMX settings.
Xciter will confirm the new values with the message 'DMX config stored!! Press any key!
Press any button to continue.
7. Press [ESC] to return to the advanced setup.
Xciter user manual
Advanced setup
39
Advertisement
Table of Contents
