Martin Xciter User Manual page 22

Fixture library
a. Use ARROW or SCR1 to select a control channel.
b. Press [EDIT] to set the parameters of the selected channel.
c. Use SM 1-6 to modify the parameters of the selected channel.
To fine-tune a value, you can hold the SM bounce button while you turn SCR2.
d. Use SM bounce button 1 to toggle between coarse and fine (MSB and LSB).
Upper case indicates a coarse channel; lower case indicates a fine channel.
e. [STORE] to store the parameters of the selected channel.
6. Repeat the previous steps (a – e) until you have configured all control channels.
Xciter checks whether you have configured all control channels before exiting the fixture definition editor. If
not Xciter asks you to retry.
7. Press [ESC] to return to the fixture definition editor.
8. Press {Advanced Config} to go to the advanced configuration menu.
9. The Lamp on, Lamp off and Reset procedures are programmed in the same way. We will use Lamp on as
an example.
10. Press the softkey next to the procedure you wish to make.
11. Press [LOAD] to create a procedure in case there is none.
Xciter adds the first step automatically.
If you are editing a fixture definition you can also press [EDIT] if you want to modify an existing procedure or press
[CLEAR] to delete it. Xciter asks for confirmation. Press [ENT] to confirm, [ESC] to cancel.
22 Xciter user manual