Midi - Martin Xciter User Manual

Advanced setup

12.2 MIDI

These settings are only useful if you are linking a MIDI device to Xciter's MIDI input.
MIDI notes can launch cues and bounce playbacks. Program changes can only launch cues.
1. Press {MIDI} in the advanced setup.
On the left you have the Xciter show elements and on the right the MIDI commands to launch them. If there
is no MIDI command linked to the show element, 'NO cmd' will appear behind the show element.
2. Press {Cue 0/00}.
3. Use PG and NL 1-20 to select a cue. Example: select cue 15 on page 2.
4. Press the softkey next to the MIDI command. Example: {NO cmd}.
5. Xciter asks you to send a MIDI command. Example: change to program 8 on your MIDI keyboard.
6. Press [ENT] to confirm or [ESC] to cancel.
7. Xciter links the MIDI command to the selected cue.
8. Press {PB 0/00}.
9. Use SCR2 and SM bounce buttons to select a playback. Example: select playback 4 in bank 10.
10. Press the softkey next to the MIDI command. Example: {NO cmd}.
11. Xciter asks you to send a MIDI command. Example: press note 20 on your MIDI keyboard.
12. Press [ENT] to confirm or [ESC] to cancel. Xciter links the MIDI command to the selected playback.
13. Repeat these steps until you have assigned all MIDI commands you need to Cues and playbacks.
14. Press [ESC] to leave the MIDI configuration. Xciter asks to store the new settings.
15. Press [ENT] to confirm or [ESC] to decline.
40 Xciter user manual