Example Bora
Making tilt actuator accessible
1.
Remove legrests
2.
Release seat (1) and tilt forwards.
3.
Disconnect remote bus cable from power module or ACT.
4.
Lift seat out of front anchorage and remove it. The seat has a
heavy weight. Use proper lifting techniques.
5.
Remove both battery cases (see "Removing battery cases" in
service manual).
6.
Pull actuator plug out of power module.
7.
Actuator able is secured inside the frames with cable ties.
Remove cable ties with oblique pliers.
Replacing actuator
Remove SL retainer clip B on the bottom fixing bolt A with
1.
the screwdriver.
Remove SL retainer clip B on the bottom fixing bolt A with
2.
the screwdriver.
Pull fixing bolt A out.
3.
4.
Remove SL retainer clip B on the top fixing bolt A with the
screwdriver.
1528338-P
Pull fixing bolt A out.
5.
6.
Pull spindle with actuator out.
Installing actuator
1.
Reinsert fixing bolts and SL retainer clips. Fix SL retainer clips
securely to fixing bolt with the hammer.
2.
Secure actuator cable to the frame with cable ties. The cable
must be routed so that it does not rub or get trapped.
3.
To complete, check all seat tilting functions.
5.11.2 Replacing lifter
•
For lifter with old seating systems see revision 15 of
this service manual.
•
For lifter with Modulite seat system see below or
Modulite service manual.
Replacing lifter/tilt module
CAUTION!
Risk of crushing
The seat is very heavy. Danger of injury to hands and feet.
– Use proper lifting techniques.
Tools:
•
3 mm Allen key
•
5 mm Allen key
•
T25 Torx wrench
•
T40 Torx wrench
•
Side cutting pliers
•
Cable ties
Description below does not apply for powered tilt with fixed
pivot point.
Replacement of the lifter/tilt module follows the same
specified order of steps for all mobility devices mentioned in
this manual. However, brackets differ for each model, see
table below.
Interface
Bora tilt bracket,
Spectra XTR tilt
bracket
TDXSP2 lifter-tilt
bracket, TDX
SP2
NB
lifter-tilt
bracket
FDX lifter-tilt
bracket
Service
35