Table of Contents
Advertisement
Invacare® Bora® / Spectra® XTR Series
1.
For position of the plugs see corresponding controls manual or
earlier revision of this manual.
2.
Remove legrests.
3.
Release seat A and tilt forwards.
4.
Disconnect remote bus cable from power module or ACT.
5.
Lift seat out of the front anchorage and remove it. The seat has a
heavy weight. Use proper lifting techniques.
6.
Remove both battery boxes (see Removing battery boxes, page
30).
7.
Remove front headlight plug from lighting PCB.
8.
Free cable or remove any cable ties.
9.
Loosen nut (2) with a 7 mm jaw spanner and a 3 mm Allen key.
10. Remove front headlight (1) from lamp holder (3).
11. Install parts in reverse order.
12. Test all functions.
5.10.2 Replacing front lamp holder (LED light)
Tools:
•
7 mm jaw spanner
•
3 mm Allen key
•
TX25 screwdriver
•
Oblique pliers
•
Cable binder
1.
Loosen nut (2) and remove.
2.
Remove front headlight (1) from lamp holder (3) and place it
carefully to the side.
3.
Undo and remove screws (4) with a TX25 screwdriver.
4.
Replace lamp holder (3).
34
5.
Install parts in reverse order.
6.
To complete, check all vehicle functions.
5.10.3 Replacing rear light (LED light)
Replacing an individual LED is not possible. If there is a
defect, replace the entire rear light.
Tools:
•
Phillips screwdriver
•
TX40 screwdriver
•
Oblique pliers
•
Cable binder
1.
For plug position, see corresponding controls manual or earlier
revision of this manual.
2.
Remove legrests.
3.
Release seat A and tilt forwards.
4.
Disconnect remote bus cable from power module or ACT.
5.
Lift seat out of the front anchorage and remove it. The seat has a
heavy weight. Use proper lifting techniques.
6.
Remove both battery (see Removing battery boxes, page 30)
7.
Remove drive wheel (see 5.7.1 Replacing drive wheel, page 20).
8.
Remove rear light plug from lighting PCB.
9.
Free cable or remove any cable ties.
10. Undo Phillips screw (1) and remove it together with washer.
11. Remove rear light (1) from splash guard and replace it.
12. Install parts in reverse order.
13. To complete, check all vehicle functions.
5.11 Seating
•
This manual refers to configurations with Modulite seat system.
Older specifications (for example Flex2 seat system) have been
described in revision 15 of this service manual.
•
For seat systems, refer to the corresponding manual.
5.11.1 Replacing actuator — powered tilt with fixed
pivot point
When an electrical adjustment option is retrofitted, then this
option needs to be activated in the driving program as well.
Tools:
•
Flat screwdriver width approx. 6 mm blade
•
Oblique pliers
•
Small hammer
•
Cable binder
1528338-P
Advertisement
Table of Contents
