Replacing The Shark Electronics - Invacare Dragon Service Instructions Manual

®
Invacare - Dragon / Tiger
7.3

Replacing the Shark Electronics

Pre-requisites:
· Phillips screwdriver
· To modify a drive program you will need: Programming software or a Handheld Programmer
and the Installation Manual of the Shark Electronics (Part Number 1436160), available from
Invacare®.
Note
All electronic modules are supplied with a standard drive program. If the driving program has been
customised, then you will have to perform this customisation again, after installing the new
electronic module.
WARNING!
Every alteration to the drive program can influence vehicle handling and the tipping
stability of the wheelchair!
· Alterations to the drive program must only be carried out by trained Invacare®-dealers!
· Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for unaltered standard drive programs!
·
Unscrew the handwheels (screws) (1) on
both sides of the panelling for the
electronics.
·
Remove the electronic panelling.
·
Disengage all the plugs (1) on the electronic
module.
SERVICE MANUAL
25