Print Server - Roland FJ-500 User Manual

4 User's Reference
3 Verify the hardware address for the

print server.

The print server's hardware address is required to set the IP
address for the print server.
Check the label affixed to the FJ-500/400 and verify the
hardware address.
The explanations in this section use 00C0EB0001FF as the print
server's hardware address.
4 Set the IP address for the print server.
Settings for Windows 98/95
The following procedure describes how to set the IP address for
the print server.
1) From the [Start] menu, point to [Programs] and choose
[MS-DOS Prompt].
2) Run this: arp -s <IP address> <hardware address>
For the IP address, specify the IP address for the print
server you decided on in "1 Confirm the IP addresses of
the computer and the print server."
For the hardware address, specify the hardware address for
the print server you verified in "3 Verify the hardware
address for the print server."
Here, enter arp -s 192.168.0.123 00-c0-eb-00-01-ff as an
example, then press the [ENTER] key.
3) Run this: ping <IP address>
For the IP address, specify the IP address for the print
server you decided on in "1 Confirm the IP addresses of
the computer and the print server."
Here, enter ping 192.168.0.123 as an example, then press
the [ENTER] key.
This completes the setting of the IP address for the print server.
78
RJ-45 (Ethernet) connector
Hardware address