Roland FJ-500 User Manual page 34

2 Basic Operation
Specifying a location in the left-right direction (the direction of carriage movement)
1 Press the [ ] key to move the carriage to the present
starting location for printing in the left-right direction.
Use the [ ] and [
2
new print-start position.
Press the [BASE POINT] key.
3
- If the carriage moves away from the standby position when not printing, problems such as drying-out of the printing heads or dot drop-
out during printing may occur. For this reason, about 60 seconds after pressing the [
to the standby position.
Also, the carriage returns to the standby position when about 20 seconds passes during this interval after the [
released.
If the setting could not be made in within the time limit, then do the setting over again from the beginning.
- The starting location set by pressing the [BASE POINT] key is released after printing one page.
32
] keys to move the marker to the
Starting location for
printing in the left and
right direction
The BASE POINT LED lights up
To release the starting location that
has been set...
• Set a new starting location in a different location.
• Press the [SETUP] key to cancel the setup for the
material (making the SETUP LED go out).
] key to move the carriage, the carriage returns
Right-hand edge
of the material
Marker
] and [ ] key is