Roland FJ-500 User Manual page 87

[SHEET SET ERROR SET AGAIN] appears and the material cannot be
detected even when the [SETUP] key is pressed
If the material loaded on the unit is transparent, then at the [SHEET TYPE] menu, select [CLEAR].
1
Press the [MENU] key and [
following screen appear on the display.
2 Press the [ ] key to make the following screen appear
on the display.
3
Use the [ ] and [
press the [ENTER] key.
Specify a printing area for the left-right direction (the direction of carriage movement) that matches the width of the material.
4
For more information, see " 2-5 Printing -- Printing at the Desired Location -- Setting the printing area in the left-right direction
(the direction of carriage movement)."
- When the setting for [SHEET TYPE] is changed after setup for the material has been performed, the setup for the material is
automatically canceled. If this happens, set up the material again.
- When using opaque material, return the [SHEET TYPE] setting to [OPAQUE].
When [SHEET TYPE] is set to [CLEAR], the material width is not detected during material setup. This
means it is necessary to specify a printing area that matches the actual width of the material.
When only set to [CLEAR], the width of the printing area is set as follows.
- FJ-500
- FJ-400
The out-of-ink screen appeared during material setup.
A cartridge has run out of ink, and printing cannot be started.
If printing data is being sent, this message is displayed and the
buzzer sounds. At the same time, operation is paused. Replace
the empty cartridge with a new one to start printing.
] key to make the
] key to select [CLEAR], then
1351 mm (53-3/16 in.) : The printing-area default for material having a width of 54 in., which is the
maximum loadable material width
1097 mm (43-3/16 in.) : The printing-area default for material having a width of 44 in., which is the
maximum loadable material width
SHEET TYPE
OPAQUE OPAQUE
SHEET TYPE
OPAQUE CLEAR
O___G _c _m _
K __C M Y __
4 User's Reference
MENU
SHEET TYPE
85