Roland FJ-500 User Manual page 36

2 Basic Operation
7 Use the [ ] and [
right edge of the carriage to the location you want to
make the left edge of the printing area. Press the
[ENTER] key to lock in the setting the left-hand edge
with an audible beep.
8 Press the [ ] key to display the screen shown in the
figure.
When you do this, the carriage returns to the standby
position.
- If the carriage moves away from the standby position when not printing, problems such as drying-out of the printing heads or dot drop-
out during printing may occur. For this reason, about 60 seconds after pressing the [
to the standby position.
Also, the carriage returns to the standby position when about 20 seconds passes during this interval after the [
released.
If the setting could not be made in within the time limit, then do the setting over again from the beginning.
- After setting the printing area, pressing the [SETUP] key to cancel the setup for the material (making the SETUP LED go out) cancels
the printing area that has been set.
- Using [PRINT AREA] to set the printing area when the starting location in the left-right direction has been specified with the [BASE
POINT] key, the setting made with the [BASE POINT] key is canceled.
- When the printing area is set to the full width of the material, fluctuations in material-width detection or slight crookedness of the
material may result in printing outside the material, causing soiling of the platen. If this happens, then do not specify a printing area.
Instead, use the default printing area in effect when the material is set up.
34
] keys to move the marker at the
MENU
PRINT AREA
] key to move the carriage, the carriage returns
] and [
Marker
] key is