Fault Codes; List Of Fault Codes - ESAB Origo TA23 Instruction Manual

GB
Control panel TA23
Function
C = Arc Force
d = drop welding
F = regulator type
H = Hotstart
Arc force
The arc force is important in determining how the current changes in response to a
change in the arc length. A lower value gives a calmer arc with less spatter.
Drop welding
Drop welding can be used when welding with stainless electrodes. The function
involves alternately striking and extinguishing the arc in order to achieve better
control of the supply of heat. The electrode needs only to be raised slightly to
extinguish the arc.
Welding regulator
Welding regulator is a type of control that produces a more intense, more
concentrated and calmer arc. It recovers more quickly after a spot short-circuit,
which reduces the risk of the electrode becoming stuck.
S
ArcPlust (0) is recommended with basic type of electrode
S
ArcPlustll (1) is recommended with rutile and cellulosic type of electrode
Hot start
Hot start increases the weld current for an adjustable time at the start of welding,
thus reducing the risk of poor fusion at the beginning of the joint.
4

FAULT CODES

The fault code is used to indicate that a fault has occurred in the equipment. It is
indicated in the display by an E followed by a fault code number.
A unit number is displayed to indicate which unit has generated the fault.
Fault code numbers and unit numbers are shown alternately.
If several faults have been detected only the code for the last occurring fault is
displayed. Press any function button or turn the knob to remove the fault indication
from the display.
NOTE! If the remote control is activated, deactivate the remote control by pressing
to remove the fault indication.
4.1

List of fault codes

U 0 = welding data unit
U 1 = cooling unit
bi15d1ea
Settings
0 - 99
0 = OFF; 1 = ON
1 = ArcPlust II; 0 = ArcPlust
0 - 99
U 2 = power source
U 4 = remote control unit
- 9 -