Table of Contents
Advertisement
GB
4
WELDING DATA MEMORY
Two different welding data programs can be stored in the control panel memory.
Press button
memory. The welding data is stored when the green indicator lamp starts to flash.
To switch between the different welding data memories press button
.
The welding data memory has a back--up so that the settings remain even if the
machine has been switched off.
5
FAULT CODES
Fault codes are used to indicate that a fault has occurred in the equipment. It is
indicated in the display by an E followed by a fault code number.
A unit number is displayed to indicate which unit has generated the fault, for example
U 0.
If several faults have been detected only the code for the last occurring fault is
displayed. Press any function button or turn the knob to remove the fault indication
from the display.
NOTE! If the remote control unit is activated, deactivate the remote control unit by
pressing
to remove the fault indication.
5.1
List of fault codes
Unit number:
U 0 = welding data unit
U 4 = remote control unit
bi20e
or
for 5 seconds to store the welding data in the
U 2 = power source
- - 9 - -
or
Advertisement
Table of Contents
