Table of Contents
Advertisement
Remote Spot Light (Optional)
The installation of the remote
spot
light
requires
installation of the rigid T-top.
The
remote spot light is
mounted to the forward area
of the rigid top. To operate
the remote spot light, locate
the remote spot light panel
that
is
installed
on
console.
The switch on the right side of the panel allows you to turn the light on and off. The red LED light located in the
center of the panel will be lit when the spot light is turned on. Once the spot light is turned on, the all around
toggle lever (also located on the remote spot light panel) can be moved in an up, down, left or right position to
rotate the light assembly in the desired direction.
Spreader Lights and Courtesy Light (Optional)
The installation of the spreader lights and
courtesy light requires the installation of
the rigid T-top.
The spreader lights are
mounted to the aft side of the rigid T-top
frame, next to the T-top rod holders. The
dome shaped courtesy light is mounted to
the bottom of the T-top storage box. Two
(2) push in switches for the spreader lights
and courtesy light are located on the base
of the dome shaped courtesy light.
•
To operate the dome shaped courtesy light - Press the switch labeled courtesy once to turn on
the white courtesy light. When you press the same switch a 2
be turned off and the red courtesy light (for night vision) will turn on. Press the same switch a 3
time to turn off the red courtesy light.
•
To operate the spreader lights - The spreader light switch operates in the same manor as the
courtesy light but only needs to be pressed in once to be turned on and once again to be turned
off.
Instrumentation
Compass
The compass is located on the dash on top of the console. To ensure
that the compass light is working properly, press the Nav switch in the
forward position to turn on the red LED light inside the compass. When
finished, turn the Nav switch back to the middle position.
Please refer to the owner's manual provided by the manufacturer of the
compass for operational procedures and for information related to the
care and maintenance of their product. When in doubt, always defer to
the compass manufacturer's instructions and/or recommendations.
Horn - Electric
The horn is used to signal, warn or alert other boats or persons on shore. The horn switch is located on the
switch panel. The horn device is located on the starboard side of the deck, forward of the rope locker. Depress
the horn switch to the up or forward position to activate the horn, then release the horn switch to deactivate the
horn. Using different sequences of horn blasts indicates different and sometimes dangerous situations to you or
someone around you.
See the Safety section in this manual for more information. Avoid any horn use without an appropriate purpose.
Additional information regarding audible warning signals should be covered in a safe boating course.
Remote spot light
the
the
Spreader lights
nd
time, the white courtesy light will
Remote spot light control panel
Courtesy/Dome light
rd
18
Advertisement
Table of Contents
