Table of Contents
Advertisement
A tripped breaker will protrude or move from its set position indicating that the circuit has been overloaded. Turn
off the device(s) on the circuit, then reset the breaker by pushing in once or by returning a breaker switch to the
on position. If the breaker does not reset or if it resets and then trips again after the device is turned back on,
then a short circuit exists or your device may be damaged, overloaded, or faulty. Correct the problem and then
reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either the
breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
Switch and Breaker Panel
The switch and breaker panel is located on the console. The numbers shown above each switch in the photo
below correspond with the following descriptions provided for each switch:
Circuit Breakers – On the switch panel below the individual switches. Actual of switch locations may vary.
1
2
1
Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore. Depress the horn
switch to the up or forward position to activate the horn. Release the horn switch to deactivate the horn.
Using different sequences of horn blasts indicates different and sometimes dangerous situations to you or
someone around you. Avoid any horn use without an appropriate purpose. See the Safety Section in this
manual and/or take a safe boating course for more information on the proper use of the horn.
2
Navigation and Anchor Lights - Locate the Nav. light switch on the instrument panel. This is a 3-way switch
(forward, middle, back/aft) that functions as follows when you press the switch:
•
Forward position - Turns on the bow lights and the anchor light. This position will also
activate the red light in your compass.
If you have Faria gauges on the dash panel, this function will illuminate the
o
gauge lights.
If the gauges were provided by the engine manufacturer (i.e., Mercury,
o
Honda, etc.), this switch will not illuminate the gauge lights. Instead, your
gauge lights will be illuminated when the ignition switch is turned on.
•
Middle position – All lights are off.
•
Back/Aft position – Anchor light is on; the bow lights and gauge lights are off.
3
Wiper (Optional) – This "2 position switch" activates the windshield wiper. Depressing the switch to the up or
forward position activates the wiper. Depressing the switch to the down or aft position turns the wiper off
4
Forward Bilge, Bilge Pump 1 and Bilge Pump 2 - Your boat is equipped with 3 automatic bilge pumps. The
5
forward bilge pump and float switch are located in the head area. The 2 aft bilge pumps and float switches
6
are located in the aft bilge (below the bilge hatch).
Bilge pumps are wired automatic to the battery and have a manual override located at the switch panel on the
console. The automatic float switches are wired directly to the Starboard battery terminals through breakers
or inline fuses. The circuit breaker is located at the helm next to the manual switches. Depressing the
applicable bilge pump switch to the up or forward position activates the pump.
3
4
5
6
7
8
9
10
11
12
13
15
Advertisement
Table of Contents
