Brocade Communications Systems FCX Series Hardware Installation Manual page 29

TABLE 9
LED
Diag
(Diagnostic)
A or S
(Active or Standby)
Up Link or Down Link (Stacking uplink or
downlink port status)
Stack ID (1-8)
FIGURE 20 Power status LEDs
1. Power status LEDs
TABLE 10
LED
DC OK
AC OK
Brocade FCX Series Hardware Installation Guide
53-1002977-01
System status LEDs (Continued)
Power status LEDs
Condition
Green
Red
Green
Off
Condition Status
Flashing Green System self-diagnostic test in progress.
Green System self-diagnostic test successfully completed.
Amber System self-diagnostic test has detected a fault.
(Blower, thermal or any interface fault.)
Green The device is the Active controller. If this LED is
flashing green, the system is initializing.
Amber Indicates the device is the Standby controller.
Off Device is operating as a stack member, or is in
standalone mode.
Green Uplink is operating normally.
Off Uplink has failed or there is no link.
Green Indicates the device stack ID.
Status
DC output ok
DC output fail
AC input ok
AC input fail
Product Overview
27