Control Unit - Mitsubishi 2013 Outlander Service Manual

ENGINE-ECU
Input
sensor
Engine-ECU is installed in the engine room.
Engine-ECU judges (calculates) the optimum control
to deal with the constant minute changes in driving
conditions based on information input from the sen-
sors and drives the actuator. Engine-ECU is com-
posed of 32-bit microprocessor and Random Access
Memory (RAM), Read Only Memory (ROM) and
ENGINE-ECU CONNECTOR INPUT/OUTPUT PIN ARRANGEMENT
Terminal Terminal
No. code
1 OCVI
3 INJ2
5 CIL2
8 SGT
10 TPSM
MULTIPOINT FUEL INJECTION (MPI)

CONTROL UNIT

CONTROL UNIT
Input
interface
RAM
Terminal name
Inlet oil feeder control valve
No. 2 injector
No. 2 ignition coil
Crank angle sensor
Throttle position sensor
(main)
Engine-ECU
Microprocessor
ROM
Input /Output interface. Engine-ECU uses
flash-memory ROM that allows re-writing of data so
that change and correction of control data is possible
using special tools. It also uses Electrically Erasable
Programmable Read Only Memory (EEPROM) so
that studied compensation data is not deleted even if
battery terminals are disconnected.
Terminal Terminal
No. code
2 INJ1
4 CIL1
6 NTSW
9 5V
11 TPSS
Output Output
interface actuator
Terminal name
No. 1 injector
No. 1 ignition coil
Starter active signal
Sensor supplied voltage
Throttle position sensor (sub)
13A-5
M2132021500960
AK602218AD
AK602565 AB