Abs-Ecu - Mitsubishi 2013 Outlander Service Manual

35B-8
NOTE: .
•
*
: The ABS warning lamp and the brake warning lamp stay on until the ignition switch is turned to the
LOCK (OFF) position.
•
When the brake fluid level in the brake fluid reservoir tank is lower than the specified value, or when the
parking brake lever is pulled, the brake warning lamp turns ON.

ABS-ECU

• By integrating ABS-ECU into the hydraulic unit,
no wiring harness for sending drive signal of the
solenoid valve and pump motor is required,
assuring higher reliability.
• By incorporating the G-sensor <4WD>, no sensor
harness is required, enhancing the reliability.
• Self-diagnostic and memory functions are inte-
grated into ABS-ECU. If any malfunction is
detected by the self-diagnostic function,
ABS-ECU activates a fail-safe function and illumi-
nates the ABS warning lamp and brake warning
*
lamp .
ANTI-SKID BRAKING SYSTEM (ABS)
CONSTRUCTION DESCRIPTION
NOTE: *: The brake warning lamp is used as the
EBD control warning lamp.
• ABS-ECU detects vehicle speed from the signals
of the wheel speed sensor and its incorporated G
sensor <4WD>, recognizes the wheel rotation
status, estimates the wheel slip condition based
on the preprogrammed algorithm, and then con-
trols the solenoid valve in the hydraulic unit so
that the wheels do not lock.
M2351003001028