Mitsubishi 2013 Outlander Service Manual page 369

METER ILLUMINATION CONTROL
The brightness of the combination meter can be
adjusted in eight stages (LEVEL 1 to LEVEL 8) by
pushing the rheostat illumination switch when the
meter is illuminated. Current illumination level will be
displayed each time the rheostat illumination switch
is pushed. The illumination level can be changed by
operating the rheostat illumination switch according
to specified procedure
brightness level is as described in the table below.
BRIGHTNESS LEVEL TABLE
Brightness Dial brightness
level
Day
LEVEL 8 100%
LEVEL 7 90%
LEVEL 6 81%
LEVEL 5 71%
LEVEL 4 61%
LEVEL 3 51%
LEVEL 2 42%
LEVEL 1 32%
SERVICE REMINDER FUNCTION
When the inspection interval (alert start point in table
below) is due in accordance with the predetermined
schedule (see table below), the service reminder
indicator will be displayed when the ignition switch is
turned to the ON position. However, even if the warn-
ing condition is met, the indicator does not display
immediately. It illuminates next time when the ignition
switch is turned ON. The impending inspection inter-
val can be displayed by changing the LCD section by
SCHEDULE TABLE
Schedule
Normal
WARNING CRITERIA (WARNING START AND END POINTS)
Elapsed time
Warning start Warning end
point point
−30 days
+30 days
CHASSIS ELECTRICAL
COMBINATION METER
*
. The brightness of each
Night
100%
22.3%
10.9%
5.3%
2.5%
1.2%
0.5%
0.2%
Warning type
Elapsed time (month)
Driving distance (miles)
Driving distance (km)
Driving distance (km)
Warning start
point
− 500 km
NOTE: The brightness can be set separately for the
daytime and nighttime. The configured information is
stored in the RAM. In the initial setting of brightness,
the daytime is set at LEVEL 8 and the nighttime is
set at LEVEL 7.
Pointer brightness
Day Night
100% 100%
90% 22.3%
81% 10.9%
71% 5.3%
61% 2.5%
51% 1.2%
42% 0.5%
32% 0.2%
the meter information switch. The service reminder
indicator will go off when it is reset by operating the
meter information switch according to the specified
*
procedure , or the warning criteria (end point) shown
in the table below is satisfied.
*
NOTE: : For details about the meter information
switch special operation, refer to the Workshop Man-
ual.
Warning criteria
Every 12 elapsed months
Every 12,500 miles of driving distance
Every 20,000 km of driving distance
Warning end
point
+500 km
LCD display brightness
Day Night
100% 100%
90% 19%
81% 9.3%
71% 4.6%
61% 2.3%
51% 1.1%
42% 0.6%
32% 0.3%
Driving distance (miles)
Warning start Warning end
point point
− 482.80 km
+300 miles
54A-29