Mitsubishi 2013 Outlander Service Manual page 349

Vehicle condition
When parking
When driving at a constant speed
System component and function
Parts name
Ignition switch
Height sensor (front)
CHASSIS ELECTRICAL
Control content
When the engine is stopped with the headlamp (low-beam) ON or
when the vehicle is stopped with the headlamp (low-beam) ON and
the accelerator pedal is released, the ETACS-ECU controls the beam
direction according to the height sensor values of the change in load
resulting from getting on/off of passengers or loading/unloading of
loads.
When a vehicle starts on curb, the travelling vehicle posture changes
from the posture during parking, so that the beam direction changes.
To control the improper beam direction caused by such vehicle
attitude change, the ETACS-ECU controls the beam direction while
travelling with stable vehicle attitude. This beam direction control
while travelling with stable vehicle attitude is performed only once
between a vehicle stop and the next stop. When driving is started on a
gravel or rough road, the beam direction control is activated after the
vehicle attitude becomes stable on a paved road.
ETACS-ECU
ACB04414
Front height
sensor
ACB04435
Functional description
Supplies power to the ETACS-ECU when the ignition switch is in
the ON position.
Detects the elongation/contraction of the front suspension and
transmits the signal to the ETACS-ECU.
LIGHTING
Headlamp assembly
(integrating headlamp
automatic levelling motor)
54A-9
Rear height
sensor
ACB04436
ACC00005 AB