Mitsubishi 2013 Outlander Service Manual page 23

CYLINDER HEAD RELATION
Front camshaft
bearing cap
Camshaft
bearing
Oil feeder control
valve filter
1. CYLINDER HEAD COVER
• A Plastic cylinder head cover has been adopted.
2. PCV VALVE
3. FRONT CAMSHAFT BEARING CAP
• On each camshaft, the thrust load is supported
by No. 4 bearing. The No. 1 bearings for the
intake and exhaust camshafts have a common
bearing cap.
4. CAMSHAFT BEARING CAP
• Each of the intake and exhaust camshafts is sup-
ported by five bearings.
5. CAMSHAFT BEARING
6. OIL FEEDER CONTROL VALVE
7. OIL FEEDER CONTROL VALVE FILTER
8. CYLINDER HEAD
ENGINE MECHANICAL
BASE ENGINE
BASE ENGINE
Cylinder head cover
PCV valve
Camshaft bearing cap
Cylinder head
Camshaft position
sensor
Cylinder head gasket
Oil feeder control valve
9. CYLINDER HEAD GASKET
10.VALVE GUIDE
11.VALVE SEAT
12.CAMSHAFT POSITION SENSOR
Oil hole
Water hole
• The cylinder head is made of aluminium alloy,
which is lightweight and has an excellent cooling
efficiency. The intake and exhaust ports are
arranged in a cross-flow construction. Each cylin-
der has a pair of intake ports on one side and a
pair of exhaust ports on the other side.
• A dual-layer, metal type cylinder head gasket that
excels in heat resistance and sealing perform-
ance has been adopted.
• Valve guides that are common to both the inlet
and exhaust have been adopted.
• Sintered alloy valve seats have been adopted.
11-3
M2112001002194
Valve guide
Valve seat
Water hole
AKB00849 AB