Etacs-Ecu Functions And Controls <Vehicles With Security Alarm Sensor; Customisation Function - Mitsubishi 2013 Outlander Service Manual

ETACS-ECU FUNCTIONS AND CONTROLS <Vehicles with security alarm sensor>
SECURITY ALARM FUNCTION
· Door(s) is unlocked by the
keyless entry function
or the keyless operation system.
· Inserting the key in the key cylinder
or keyless operation key is approved,
and
turning the ignition switch to ACC or ON.
When any operation above is done.
NOTE:
*: Exterior protection
OPERATION
1. Locks the doors by the keyless entry transmitter
or keyless operation key (except for operating the
door lock with the key cylinder).
2. "Ready to be armed" is set, the "Ping" tone
sounds and the security indicator starts blinking.
(The security alarm sensor is not disabled
*1
temporally .)
3. After 20 seconds, the status shifts to "Ready to be
triggered".
4. Irregular door opening or tailgate opening
(opening of door or tailgate without unlocking
using the keyless entry transmitter or keyless
operation key)
5. After the transferring to the "Warning" status, the
ETACS-ECU generates the "Beep" tone, the
hazard warning lamp flashes, and the security
alarm siren sounds intermittently (Maximum 10
times) for 27 seconds.
• With the "Ready to be triggered" status, the fol-
lowing operation or status immediately transfers
the status to "Warning".

CUSTOMISATION FUNCTION

By operating the M.U.T.-III ETACS system, the fol-
lowing functions can be customised. The pro-
CHASSIS ELECTRICAL
SECURITY ALARM
System disarmed
Door(s) is locked by the keyless entry function
or the keyless operation system
(including lock operation by the timer lock).
Ready to be armed
All doors, tailgate and
hood remains closed
for 20 seconds.
Ready to be triggered
Hood is opened.
or
Door(s) or tailgate is opened in
an unauthorized way.
Warning
*
• Open the hood.
• Abnormality in ETACS-ECU power supply
• Abnormality in communication and power
supply of the security alarm siren
*1
NOTE:
"OFF" position and the windshield mist switch to ON
for 5 seconds or longer (operate the wiper lever
upward), the buzzer incorporated in the combination
meter sounds once and the security alarm sensor is
disabled until the ignition switch is turned to the
"ACC" or "ON " position. To reactivate the security
alarm sensor, turn the windshield mist switch to ON
for 5 seconds or longer (operate the wiper lever
upward). When the security alarm is activated, the
buzzer incorporated in the combination meter
sounds twice.
ALARM HISTORY OUTPUT FUNCTION
If the exterior protection is activated between the last
OFF operation and the next ON operation of the igni-
tion switch, this function informs the driver by flash-
ing the security alarm indicator and by the buzzer.
grammed information is held even when the battery
is disconnected.
: When turning the ignition switch to the
54A-63
M2545700300399
ACC01999 AC
M2545700400482