Kipor Sinamaster I G2600 Operation Manual page 21

Low oil alarm system
The Low oil alarm system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the crankcase
falls below a safe limit, the Low oil alarm system will automatically shut down the
engine (the engine switch will remain in the ON position).
If the low oil alarm system shuts down the engine, the low oil alarm indicator
light(red) will come on when you operate the starter, and the engine will not run. If
this occurs, add engine oil.
Fuse
DC Circuit Protector
Low oil alarm
Indicator light (Red)
1.Connect the ground terminal.
2. Start each engine according to "STARTING THE ENGINE".
When the output indicator light(green)does not light and the overload indicator
light (red)lights instead, set the engine switch to STOP, stop the engine at once
and then start the engine again.
3. Confirm that the equipment to be used is switched off, and insert the plug of the
equipment to be used into the AC receptacle of unit A or unit B.
CAUTION
Confirm that the use equipment to be connected is switched off.
When the equipment to be used is switched on, it will operate suddenly, and
injuries or accidents may be caused.
Output Indicator
Light (Green)
Earth Mark
Overload Indicator
Light (Red)