Scanner Entry; Figure 17 Scan Beam; Figure 18 Scanner Led Location - LXE MX3-CE User Manual

Quick Start

Scanner Entry

To scan with the laser barcode reader, point the laser window towards a barcode and press the
Scan button. You will see a red laser beam strike the barcode.
Align the red beam so that the barcode is centered within the beam. The laser beam must cross the
entire barcode. Move the MX3-CE towards or away from the barcode so that the barcode takes up
approximately two-thirds the width of the beam.
The SCNR LED turns red when the laser beam is on. Following a barcode scan and read the
SCNR LED turns green and the MX3-CE beeps, indicating a successful scan.
The laser and SCNR LED automatically turn off after a successful or unsuccessful read. The
scanner is ready to scan again when the Scan key is pressed.
E-EQ-MX3CEOGWW-F-ARC
Read all cautions, warnings and labels before using the laser
Correct Scan

Figure 18 Scanner LED Location

scanner.
Incorrect Scan

Figure 17 Scan Beam

Incorrect Scan
MX3-CE User's Guide
17