Canon FAX-L2000 Facsimile Manual page 296

Cause 2
Remedy
Documents are streaked with lines after they print on the other fax machine.
Cause
Remedy
Your documents are printed at a reduced size on the other fax machine.
Cause
Remedy
The documents you send are too light.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cannot perform relay sending.
Cause 1
Remedy
13
Cause 2
13-14 When Trouble Occurs
You have a lot of documents stored in memory.
Delete the documents you do not need from the memory. (See "Erasing a
Document from Memory", on p. 9-22.)
The scanning glass on your machine is not clean.
Copy a document on your machine, and see if the copy is streaked or dirty. If the
copy is streaked or dirty, clean the scanning glass. (See Chapter
6,"Maintenance," in the Reference Guide.)
The document feed guides are not set properly when you scan documents for
sending.
Make sure the document feed guides are snug against the sides of the
documents you scan for sending. (See "Setting the Document on the Machine",
on p. 3-3.)
The Lighter indicator above [Contrast] on your operation panel is 'ON'.
Press [Contrast] until 'Standard' or 'Darker' is selected. (See "Adjusting the Scan
Settings", on p. 3-4.)
Your original document is too light.
Press [Contrast] until 'Darker' is selected, then try sending again. (See "Adjusting
the Scan Settings", on p. 3-4.)
The scanning glass on your machine is not clean.
Copy a document on your machine, and see if the copy is streaked or dirty. If the
copy is streaked or dirty, clean the scanning glass. (See Chapter 6,
"Maintenance," in the Reference Guide.)
The relay unit does not support ITU-T subaddress/password transactions.
If the relay unit does not support ITU-T subaddress/password transactions, you
cannot perform relay sending.
The relay unit has not set up a relay group correctly.