Canon FAX-L2000 Facsimile Manual page 145

The SETUP FILE menu includes the following items:
Setting
1. GROUP DIAL NAME
2. PASSWORD
3. TRIGGER
1. SUBADDRESS
2. SENDER'S FAX NO.
3. MAIL ADDRESS(To)
4. RX PASSWORD
5. SELECT ORIG UNIT
ON
TEL =
OFF*
Name (24 characters)
Enter a name for the relay group. The name can be up to 24 characters
long. Then, press [OK].
0-9999999
Enter a password (up to seven digits) to protect the relay box settings you
are about to set up. After you set a password, you will have to enter it every
time you want to view or change these settings. Enter a password, and
press [OK].
Set either of SUBADDRESS, SENDER'S FAX NO., or MAIL ADDRESS
(To) to use it as a trigger to start relay broadcasting.
This is the ITU-T subaddress. Enter a number up to 20 digits long (it can
include spaces and the symbols
the speed dialing key or code under which the originator fax machine's
telephone number is registered must be set to 'OFF'.
Enter the sender's (originator's) telephone number using one-touch or
coded speed dialing.
See the Sending Guide.
For the FAX-L2000, the installation of the optional Network Kit is necessary
to access these items.
20 digits ( , #, spaces)
If your machine is the relay unit, this ITU-T password must match the ITU-T
password of the document sent from the originator in order for your
machine to receive the document. Otherwise, your machine will not receive
the document. Enter a number up to 20 digits long (it can include spaces
and the symbols and #).
If your machine is the relay unit, this feature forces your machine to check
the identity of the originator before it receives the document, and relays it to
other fax machines.
If your machine receives a document for relay, it will check the identity of
the originator before it receives the document. In order for this feature to
perform correctly, the telephone number of the originator unit must be
registered for speed dialing on your machine.
Press the one-touch speed dialing key, or press
by the three digit code where the number for the originator machine is
registered press [OK].
Your machine will receive a document for relay without checking the identity
of the originator.
Setting Up and Using a Standard Relay Unit
Description
and #). The OPTIONAL SETTINGS for
(Coded Dial) followed
6
6-5