Renaming Hot Keys; Deleting Hot Keys; Altering Parameters In The Parameter Area; Master Parameters: M_Level, M_Delay, M_Fback, Etc - Eventide Eclipse User Manual

Eclipse User Manual
<ASSIGN>
Press to actually assign it. If the hot keys "slot" you chose
was unoccupied, the Eclipse will assign the hot key without hesitation.
However, if the slot you chose was occupied, the Eclipse will verify that
you would like to replace the old hot key with the new one.
{IN GAIN}
OK, while that was instructive, you probably won't assign global parameters (such as ) to the
area too often. Instead, you'll usually assign program parameters.
HOT KEYS

Renaming Hot Keys

To rename an existing hot key, press and hold the hot key you want to
<NAME>
rename in the area. A soft key appears that, if
HOT KEYS
pressed, allows you to change the name of the hot key. Hit the
HOT
key to finish. Blank spaces are not allowed in Hotkey names.
KEYS
Eclipse will automatically replace all blank spaces with '_' (underline)
characters.
 see page 32 to learn how to name things

Deleting Hot Keys

To delete a hot key assignment, either overwrite the assignment with a
new hot key (as described above) or press and hold the hot key you
<REMOVE>
want to delete in the area. A soft key appears
HOT KEYS
that, if pressed, deletes the hot key in question. The Eclipse makes sure
you really want to go through with it...

Altering Parameters in the PARAMETER Area

While most factory programs link to their most important parameters in
the area, those same parameters and many more are left to
HOT KEYS
PARAMETER <EDIT FXA>
tinker with in the area. Press or
PARAMETER
<EDIT FXB>
depending on which effects block holds the parameters you
wish to tweak.
FXA
Hey! Many programs only make use of one of effects block A ( ), in
PARAMETER <EDIT FXA>
which case you can only edit .
<EDIT FXA> <EDIT
We'd like to take you through all of the myriad parameters you'll encounter under or
FXB>
, but there are too many and they are too varied. Instead, we'll make a few general comments. For
more "algorithm-specific" comments and algorithm flow charts, see the separately provided "Eclipse Al-
gorithms" document.

Master Parameters: M_LEVEL, M_DELAY, M_FBACK, etc.

Many algorithms have multiple implementations of the same sort of pa-
dual filters
rameter. For example, the algorithm has two filters, one for
each channel. While you can change each filter's cutoff frequency and
resonance independently, you'll usually want to change them simultane-
ously.
m_pandelays
Similarly, the algorithm has four delays. You'll often
want to alter their delay times relatively by scaling each delay time by
some amount.
The inconvenient alternative is to go into each delay and change its
absolute delay time.
Eclipse User Manual Page 34 of 66 Release 4.0.1