The Top Line Of The Display; Altering Parameters - Eventide Eclipse User Manual

You know you're a level down because a little triangle appears in the lower right corner of
the screen. To come "back up," press the area key for the area you're in
press
LEVELS
(parentheses)
are for individual parameters. Here we see
(WET/DRY)
^_BACK
This special soft key sends you "up a level." Here we see
PARAMETER <EDIT MOD>
been pressed a few times. Pressing
to the normal
Before we move on to the top line of the display, we should point out a
little graphic you may notice on the bottom right corner of the screen.
It's a number next to a right pointing arrow. This graphic indicates that the area you're in has more than
one "page." The number is the page you're on. Pressing
in the screen to the right. As shown, we're on page 1 and we know there are other pages because there's an
arrow.
To flip to the other pages, press the area key associated with those pages.
Here we've pressed the
arrow relative to the page number. If the arrow is to the left of the page
number, it indicates that pressing the

The Top Line of the Display

The top line of the display usually shows what area you're in (e.g.,
, ,
LEVELS SETUP PROGRAM
lighted soft key.
The area breaks from this convention a bit, with the first
PARAMETER
page showing which algorithms are loaded into each effects block and
whether each effects block is muted or not. You'll find a few other such
anomalies, but they shouldn't be too hard to figure out.
Once you highlight a
the display will show a parameter (or parameters) that you can adjust. To
adjust a parameter you can...
 Turn the knob!
 Key in a value with the keypad, pressing
by pressing either before the keyed number or after the keyed number. If you key in a number that
+/-
is "out of range," the highest or lowest value available will be shown. If you don't press
number you typed won't "stick"!
ing in a value. For example, if you key in a delay time of
333.333
!
 Press the
/
INC DEC
Release 4.0.1
Eclipse User Manual
LEVELS METER
. Try this on
)
.
after the
area screen.
PARAMETER
key again. Notice the position of the
LEVELS
LEVELS
, etc.) and the parameter value for the high-

Altering Parameters

(NORMAL) {GANGED}
or
NOTE: You can often obtain greater precision than the display will show by key-
keys (the little up and down arrow in the keypad).
Page 13 of 66
.
LEVELS
key has
PARAMETER
^_BACK
sends us "up"
after being in some other area will result
LEVELS
key again will take us back to the first page.
soft key, the top line of
when you're finished. Negative values can be entered
ENT
333.333
, the display will read
(in this example, we'd
333
. But the actual value will be
Eclipse User Manual
, the
ENT