Eventide Eclipse User Manual page 20

Eclipse User Manual
Finally, let's assign the modulation block's LFO to a parameter. Press
<EDIT MOD> LFO#1 (T_RATE) whole
page 2 , and set to
PARAMETER
note
. Now the modulation block's LFO is cycling once a measure. Use
^-BACK
 see page 43 for information on the modula-
the soft key to "jump up" a level.
tion block LFO and all of the other wonderful modulators!
All of the modulators in the modulation block exist independently of
CombDelays
programs. To prove it, load the program . Should you peek
(T_RATE)
back at the LFO's , you'll find it hasn't changed.
(M_COMB) 0 %
Now go to the area and set to .
HOT KEYS
To assign the modulation block's LFO to this parameter, hold down its
soft key until the page shown to the right appears.
<MODULATE> (SOURCE) LFO#1
Select and then set to . Trippy!
(SCALE)
You can change the depth of the effect with .
(SOURCE) off
 see page 40
To disconnect modulation, simply set back to .
for more information about patching parameters to the modulation block
Eclipse User Manual Page 18 of 66 Release 4.0.1