Eventide Eclipse User Manual page 44

bipolar bipolar
In the example above, the parameter value will vary between 1,500 and 2,500 (centering
on the base value). Note that for bipolar, the scale setting reflects the amount the parame-
ter will vary above and below the base value.
absolute absolute
minimum to maximum parameter for the swing of the modulation.
In the example above, the parameter value will vary between 20 and 2,000.
min/max min/max
values of the modulation range. To enable this, the
knob is replaced by a
again to get back to
So, continuing our example, we would select
get modulation between 2,000 and 4,000Hz.
lfo#1
Finally, select under
For a good time (or to troubleshoot), watch your parameter vary (
Eclipse User Manual
Eclipse User Manual
uses the base value as a starting point and modulates above and below it.
ignores the base value and passes the modulation right through, going from
allows you to set the maximum and minimum
(MAXIMUM/MINIMUM)
(MAXIMUM)
(SOURCE)
.
Page 42 of 66
(SCALE)
knob. Hit it once for
.
unipolar (TYPE)
under
(FREQ)
(MINIMUM)
to
in this case). Neat!
Release 4.0.1
and