Eventide Eclipse User Manual page 19

Press the
PROGRAM
information
<  >
Press the and
Programs-Guitar
. Now you can access programs that were designed to
process guitars. Use the knob to select the program
Load the program by pressing the conspicuously labeled
key. You're whisked away to the
Too much distortion? Select the
out
select .
Press the
HOT KEYS
(SENS)
funk? Select and use the knob to tune in the "good stuff"!
OK, let's load a different program that has an LFO so we can check out
the Eclipse's tempo feature. Go back to the
<  >
soft key until the left side of the display reads
Use the knob to select
To insure that your tempo is behaving in a way that makes what follows
SETUP TEMPO (TAP SRC)
comprehensible, set
experiment with other settings (such as the all-important
As an important aside, selecting
Return to the
HOT KEYS
time. You'll notice that the tempo is displayed (with less precision than
it truly possesses) and that the program's modulating filters get all cozy
and synchronized with the music.
HOT KEYS (T_RATE)
Select
whole note 1/8 note
as or
Notice that if you alter
affected. It works like this: you select the source of the tempo as
described above. The tempo then "informs" all the
T_xxxxx
and parameters in the program that is loaded. They "filter" the
tempo information based on the rhythmic value you choose and
(DELAY)
"inform" the actual
their "native language" (e.g., milliseconds or Hertz).
(DELAY)
The "unadorned"
tempo and their associated
back to the "unadorned" parameters, either turn off the tempo system as
described above, or turn off a given
keep spinning the knob to the right; you'll get there!). Doing either ef-
fectively breaks one of the arrows shown to the right.
 see pages 15 and 35 for more information
Release 4.0.1
Eclipse User Manual
key again to jump "up" a level.
<  >
keys until the left side of the screen reads
HOT KEYS
(FUZZ)
soft key and use the knob to
key again to access more soft keys. Need more
Dual Modfilter
and then
Off
would disable the tempo feature.
area, play some music and tap the
and play around with different values, such
. Not bad...
(T_RATE)
, the associated parameter
(RATE)
or parameters in the program in
(RATE)
and parameters are thus slaves to the
(T_xxxxx)
parameters. To relinquish control
(T_xxxxx)
Page 17 of 66
 see page 28 for more
FuzzADSRPreamp
<LOAD>
area...
area and press the
PROGRAM
Programs-All
<LOAD>
it.
Internal
to . You can
Midiclock
TAP
(RATE)
T_DELAY T_RATE
,
off
parameter to
.
soft
.
) on your own time!
key in
is
,
(just
Eclipse User Manual