Adat Output Or Two-Channel Optical Output - Eventide Eclipse User Manual

SETUP DIG-OUT FORMAT (EMPHASIS)
By changing
output audio. If you've never heard of "emphasis," leave it
Emphasis is an outmoded "feature" of older A/D and D/A technology that filters the digital audio to make the best use of
available headroom. However, few devices use emphasis these days, so you probably want to leave it off unless you have good
reason to do otherwise. Changing the emphasis flag does NOTHING to the actual audio, it just turns the flag on and off (so, in
this sense, your Eclipse can misinform). Setting the emphasis to
flag.
Assuming that you've set (
SETUP DIG-OUT FORMAT (SCMS)
at
copy OK
This will allow subsequent digital devices to make unlimited copies of the output audio.
You should leave it set to
1 more
This will allow only one subsequent digital device to use the output audio. After that, no
more digital copies are permitted.
no copy
This will allow no subsequent digital devices to use the output audio. ...a good way to pro-
tect your wares from flea-bitten pirate varmints!
SETUP DIG-OUT FORMAT (BITS)
Select
24 20 16
length: , , or

ADAT Output or Two-Channel Optical Output?

The optical output can be made to send eight-channel digital audio in the
ADAT
ADAT protocol (
S/PDIF
sen above ( ).
Select between the two at
above 50kHz.)
ADAT
If you select , proceed to
ADAT-OUT
edly press
change the status of its output. Your choices are:
Thru
The selected ADAT channel will carry the same signal that the corresponding ADAT input
carried.
Mute
The selected ADAT channel will carry silence.
Ch 1
The selected ADAT channel will carry the Eclipse's channel 1 output.
Ch 2
The selected ADAT channel will carry the Eclipse's channel 2 output.
ADAT
If you select for the optical output, the other digital outputs send
the format selected at
scribed above.
Release 4.0.1
Eclipse User Manual
CS-TYPE) Cns
to
. Your choices are:
copy OK
bits.
) or two-channel digital audio in the protocol cho-
SETUP DIG-OUT (OPTICAL)
SETUP DIG-OUT (ADAT-OUT)
to select each channel in turn and use the knob to
SETUP DIG-OUT FORMAT (CS-TYPE)
Page 27 of 66
off
from to
off
thru
simply mirrors the output flag so that it matches the input
, you can select copy status
unless you feel justified in doing otherwise...
to choose the output word
. (You should not select
. Repeat-
on
, you can add emphasis flags to your
and skip the rest of this paragraph!
ADAT
for sampling rates
as de-
Eclipse User Manual