Table of Contents
Advertisement
Unpacking the Server
Manual Lifting
Manual Lifting
Use this procedure only if a HP approved lift is not available.
This procedure should only be performed by two qualified HP Service Personnel utilizing proper lifting
techniques and procedures.
System damage can occur through improper removal and re-installation of devices. This task must be
performed by trained personnel only. Instructions for removing and re-installing components can be found in
the Removal and Replacement chapter of the HP Service Guide: rp7405/rp7410.
CAUTION
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Step 1. Follow the instructions on the outside of the server packaging to remove the banding and cardboard
top from the server pallet.
Step 2. Remove both server side covers and if present, the front bezel.
Step 3. Reduce the weight by removing all bulk power supplies and cell boards. Place each on an ESD
approved surface.
Step 4. Locate server lift handle panels.
•
Assembly, Lift Handle, Left Panel - PN: A6752-04045
•
Assembly, Lift Handle, Right Panel - PN: A6752-04048
Step 5. Orient lift handle panels as shown in Figure 2-5 on page 19 and Figure 2-6 on page 20 so lift
handles hang down flush against panel while installing. Handles lock into a horizontal lift position
for lifting.
18
Chapter 2
Advertisement
Table of Contents
