Step 1. Remove the top cover.
Step 2. Remove the PCI bulkhead filler panel.
Step 3. Lever open the Manual Retention Latch for selected slot. Refer to Figure 3-2.
Step 4. Install the I/O card in the slot.
NOTE
Step 5. Flip the Manual Release Latch for the card slot to the closed position.
CAUTION
Step 6. Press the attention button.
The green power LED will start to blink.
Figure 3-2 PCI I/O Slot Details
Step 7. Wait for the green power LED to stop blinking and remain solid green.
Step 8. Check for errors in the hotplugd daemon log file (default: /var/adm/hotplugd.log).
Chapter 3
A slow, firm pressure is needed to properly seat the card into the backplane.
Working out of sequence or not completing the actions within each step could cause
the system to crash.
Do not press the attention button until the latch is locked.
Attention LED (Yellow)
Manual Release Latch Closed
Manual Release Latch Open
Power LED (Green)
Installing Accessories
PCI/PCI-X Card Cage Assembly I/O Cards
Attention Button
39