Rack Mount System Installation; Manual Lifting - HP rp8400 Series Installation Manual

Unpacking

Rack Mount System Installation

Rack Mount System Installation
Servers shipped as a stand alone or in the to be racked configuration must have the core I/O handles and the
PCI towel bars attached at system installation. Obtain and install the core I/O handles and PCI towel bars
from the accessory kit A6093-04046. The towel bars and handles are the same part. Refer to service note
A6093A-11.
There are several documents written to help with rack mounting the server. This list is intended to guide the
HP Installation Specialist to the documentation that has been written by the Rack Solutions team. The
external Web site is http://www.hp.com/racksolutions. The internal Web site is
http://racksolutions.corp.hp.com.
Rack System/E
Detailed rack information for the rack system/e covers the following topics.
• Safety and Regulatory Information
• Description of the Standard Racks and Physical Specifications
• Installation Guidelines
• Procedures
The part number for this user's manual is 5967-6409.
Rack System/E Stabilizer Feet
The stabilizer installation guide for the rack system/e covers the following topics.
• How to Install the Stabilizers
• Moving the Rack
The part number for this installation guide is A5805-96001
HP J1528A Rack Integration Kit
The rack integration kit information covers installing the following products.
• Ballast Kit (J1479A)
• Anti-Tip Stabilizer Kit (A5540A)
• Slide Rails
• CMA (Cable Management Arm)
• Interlock Device Assembly
This installation guide provides a complete parts list of the hardware and tools required to perform the
installation of the products mentioned. Installation of the products is illustrated in this guide. The part
number for this installation guide is J1528-90001.

Manual Lifting

Use this procedure only if no Hewlett-Packard approved lift is available.
34
Chapter 3